Monday We got them held in place and tacked to the rear end so we could mount. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on year long project. List issues / Complications: 1 3 4 Me and Dylan worked on getting the dimensions to center it up. No complications. We worked on the brackets for the rear end to mount to the car. Tuesday We started designing how we would attach it and where we would locate our mounts. 2 Steps Taken to Reach Objective: Objective (s): Work in the lab on the projects. List issues / Complications: 1 3 4 I cut a piece of square tubing the correct measurement to hold the bars that we would use to connect the suspension. No complications. We discussed having a rigid rear end or suspension. We chose suspension. Wednesday We took measurements to get the length of the bars and also to see where to drill the holes. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on year long project. List issues / Complications: 1 3 4 While Dylan was getting bolts and washers I drilled the holes in the bars then we assembled them. Me and Dylan designed tabs to hold on the rear end suspension. Thursday I put spacers and washers in on the front end of the prototype. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on year long project (prototype& Formula) List issues / Complications: 1 3 4 Helped make steering straight. We tightened the control arms to bring the wheels in a little more to straighten it up. No complications Me and Dylan drilled the holes for the rear end suspension brackets and bolted them on and prepped for tacking. Friday I added my interior walls and curtain wall to meet the criteria. 2 Steps Taken to Reach Objective: Objective (s): Finish up Commercial exterior walls then work in lab. List issues / Complications: 1 3 4 Worked on formula helped disassemble rear end to get full welded. I had trouble with the curtain wall but Jared helped me and I got it figured out. I got all my ext. walls put up.