Monday I went out and helped get the two cars off of the flat bed trailer and wheeled inside. 2 Steps Taken to Reach Objective: Objective (s): Get the trailers unloaded and get everything put back in their designated spots. List issues / Complications: 1 3 4 I helped lift the tool cart down from the enclosed trailer and started cleaning it out getting all the red boxes back in the lab none I went out in the lab and did some cleaning and organizing so that we could fit everything back in the lab. Tuesday I got all the points plotted and started writing the code . 2 Steps Taken to Reach Objective: Objective (s): Work in the computer lab on my advanced G-code. List issues / Complications: 1 3 4 I got stuck figuring out the radiuses and how to get them to the correct size. I couldn’t figure out why my radiuses were too small I started working on plotting the points for my Harley Davidson bar and shield design. I tried to verify what I did and I couldn’t see anything. It said the radius was too small. Wednesday I started inventor and worked on building all the components to the c-clamp. 2 Steps Taken to Reach Objective: Objective (s): Work in the computer lab on getting prepared for the inventor certification test. List issues / Complications: 1 3 4 After I made all the parts I started working on assembly’s and putting them all together so it would work. None. I went over the sheet and looked to see what I had to design and what it would take. I worked on a little bit of my g-code fixing some errors I had. Thursday When I verified my code I had some radius issues again and some regular issues with coordinates. 2 Steps Taken to Reach Objective: Objective (s): Work in the computer lab on getting my g-code done and my granite piece cut out. List issues / Complications: 1 3 4 I got my coordinates fixed and my radii and then verified it again and it was finished. Working on getting the radii correct and proportional. I started working on finishing up my letters inside the bar and shield. I measured out a piece of granite and cut it an inch big on both sides so that it would have a nice margin and be centered. Friday I ran my code and it turned out good except for my tape idea. 2 Steps Taken to Reach Objective: Objective (s): Load project in the laser and get my piece finished List issues / Complications: 1 3 4 I cleaned up the mess I made and I was done for the week and day. none I loaded it in the machine with tape around it so that I could paint it after it was finished drilling.