Monday I cut them long so we had room to grind them and get them set to the same length. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on prototype car(Front Wheel Spacers). List issues / Complications: 1 3 4 We re-died the studs so we could get the nuts to thread on. none I got the spacer material and started cutting spacers for the front wheels. I also had to re-tap some of the nuts so they wouldn’t cross-thread Tuesday I found the right design and started drawing it on graph paper to get my coordinates. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on prototype car or work on g-code if nothing in the lab can be done. List issues / Complications: 1 3 4 I helped Nathan work on the wheel spacers for formula getting them grinded and straight. none I looked up designs for the 5.7 Hemi for my intro g-code. Wednesday I used a dial caliper to get measurements to get them grinded to the correct width. 2 Steps Taken to Reach Objective: Objective (s): Work in the lab on prototype car. Work on g-code if we have nothing to do. List issues / Complications: 1 3 4 I finished grinding all the spacers and put the wheel on and the wobble is gone. Getting the spacers perfectly straight. I worked on the passenger side front wheel working on getting the spacer even so there was no wobble in the wheel. We brought the body in and put in on the car. We also removed decals that don’t sponsor us anymore. Thursday Once we got the body set we drilled holes for our quick disconnect and pop riveted them on. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on on prototype car putting the quick disconnect body mounts on and work on G-code if all finished. List issues / Complications: 1 3 4 We specked out and marked where we need to mount the bars so they attach and hold. Getting the body set back in the perfect position. Me and Dylan worked on the body mounts and tried to get the body set right so the mounts fit correct. I put my intro g-code on graph and started marking coordinates. Friday I got the body removed and started attaching the springs. 2 Steps Taken to Reach Objective: Objective (s): Work In lab on prototype body mounts getting the springs put on and connected. List issues / Complications: 1 3 4 I got the passenger side finished and the front end done and attached. We have to fix the driver side front end mount because it is not fully centered. I speced out and marked where I need to drill to attach the springs.