Monday I changed my coordinates on my d and got it to curve but I couldn’t get my j to curve. 2 Steps Taken to Reach Objective: Objective (s): Work on circular interpellation G-coding and work on formula brakes. List issues / Complications: 1 3 4 I took measurements and got the length of brake line we would need for the front brakes. I kept messing up my j. (It kept going sideways and doing things it wasn’t supposed to) I started working on circular interpellation getting my d and j to have curves. Tuesday I finished pop-riveting the firewall in and put the wiring back on the motor that I had removed. 2 Steps Taken to Reach Objective: Objective (s): 2 Hr Delay List issues / Complications: 1 3 4 none I sanded on the shell body trying to get all the rough areas smoothed out and shaped. Wednesday I helped spec out brake lines and where we can run them. (Formula Car) 2 Steps Taken to Reach Objective: Objective (s): Help out other teams in need and Work on Formula car getting things finished up. List issues / Complications: 1 3 4 I worked on running the overflow line for the gas tank on formula and got it attached and secured. none I help sand on the shell body getting it smoothed out and contour. Thursday I waited on it to dry and put a couple coats on each and fanned it out so it didn’t look splotchy. 2 Steps Taken to Reach Objective: Objective (s): Finish G-code and touch up prototype car with the touch-up paint. List issues / Complications: 1 3 4 I finished my circular g-code and put it in the machine to inspect it and make sure the code had no errors. none I got the paint and a brush and worked on touching up all of the bare metal spots. I got both sides milled out and turned it in. Friday I suctioned it out as best as I could and it was clean. 2 Steps Taken to Reach Objective: Objective (s): Work on Formula car cleaning up the chasis and check connections. List issues / Complications: 1 3 4 I removed all connections to make sure they were soldered and very well held together. none I wire brushed the floor board and got most of the loose paint up. I replaced all the wires and make sure everything still worked correctly.