Monday I used my coding sheet to run the correct codes on Notepad with the coordinates on my graph. 2 Steps Taken to Reach Objective: Objective (s): Learn G-coding and start working on making initials. List issues / Complications: 1 3 4 I made sure to get everything perfect and plugged it in to cnc to see if my coordinates were correct. none I started by drawing my yo yo and initials on graph paper so I could have coordinates. Tuesday 2 Steps Taken to Reach Objective: Objective (s): 2 hr delay List issues / Complications: 1 3 4 none I had to move my coordinates up about a 1/16 of an inch to perfectly center my initials. Wednesday 2 Steps Taken to Reach Objective: Objective (s): 2 hr delay List issues / Complications: 1 3 4 none Worked on room number blocks facing them off for the new logos outside of the classrooms. Thursday I had to adjust the right side out a touch so it would be straight. 2 Steps Taken to Reach Objective: Objective (s): Work out in the lab on formula car and finish up CNC initial coding List issues / Complications: 1 3 4 I started pop riveting the fire wall back in so we can think about getting the seat put back in and put seat cover on. I didn’t know what measurements to take to fix steering by Nathan helped me and we got it done. I worked on getting the steering set perfectly center so we have the full range of turning. I finished pop riveting the fire wall in and cleaned up around my area. Friday I worked on my g-coding and cut my yo yo with the small bit. 2 Steps Taken to Reach Objective: Objective (s): Finish up on CNC coding and work in lab cleaning up our assigned positions. List issues / Complications: 1 3 4 I helped Dylan finish his g-code so he could engrave his initials. none I cleaned out the middle room and organized the cabinet and shelves. I checked codes on CNC for Nathan and Ross.